A 3D-printed soft robot with no electronics runs at 4.7 meters per second
Engineers at UC San Diego have built a six-legged robot made entirely of soft material that runs at up to 4.72 meters per second on air pressure alone. It is printed in one piece and still needs an air hose.

Engineers at the University of California San Diego have built what they describe as the fastest robot made entirely of soft materials. The six-legged machine reaches up to 4.72 meters per second, more than 100 times faster than the team's first air-powered walker from 2022, which managed 4 centimeters per second. It is 3D-printed in one go from a single material and contains no electronics. In tests it ran on concrete, gravel, grass, mulch and sand, went down stairs, swam, and kept working underwater. The study appears in Science Robotics.
Inside the robot is a network of chambers, valves and tubes that moves the legs when pressurized air flows through. To go faster without wasting air, the team borrowed an idea from the compound steam engine: the air is used twice, first in small high-pressure chambers that switch the valves, then in larger low-pressure chambers that move the legs. The work was led by Yichen Zhai and Professor Michael Tolley. For now the robot only runs while connected by hose to a compressor, and it cannot steer.
Why it matters
Soft robots are cheap to make and hard to break, but they have been slow, which limited what they could be used for. A robot with no chips or motors that can be printed on a desktop machine could work where electronics fail, such as areas with strong radiation or magnetic fields. The researchers say the next steps are designs that use less air, so the robot can carry its own cartridge, and legs that can steer.